Ricoh plockmatic booklet maker belt removal

#Ricoh plockmatic booklet maker belt removal manual

If the EEPROM or the CPU PCB has been replaced, this procedure must beДuring the procedure, the side jogger motor and staple/fold positioning motor movesД«etween given positions to calculate this specific motors characteristics in conjunction Of side guides, staple stop or fold stop, this procedure must be performed. '5.4 PAPER SIZE RESETIf any mechanical adjustments have been carried out that effects the positioning This is where I reset the EEPROM settings (again, this was a new machine to me, so thought it might be that). I Service Mode, but I don't see any fold stop or staple stop settings.

This is just exaggerated on the DLT and the staples are not on the center of the fold (out about 1/2 inch).Дў. Just to clarify - it staples on the fold at LT, but doesn't fold on center - one side is slightly longer than the other. I have burned through a box of paper thinking that I could outwizard it on user settings. I have tried every size setting from auto to custom. Seems I have you on the hook I will explain with a little more detail and maybe you can help me out (or ask someone you know who knows):ДЎ. There are lines on all the pages as well because the fuser that was just rebuilt is apparently still having problems too (but whatever, actual printed pages is amazing)!! My husband calls the whole thing a boat anchor and I can't help but agree with him.ДЄnyway - before waving the white flag completely I'm going to see if I can figure this 5010 out and see if it can't fold a few books. Today was the first day the C901 printed a damn thing - a whopping 1200 pages for a magazine that I now have in spreads in my car to take to a print house tomorrow to bind and trim for me (because problematic still isn't working right!!). Thank you Rorschch so much for your response!! I have a small graphic design company and bought a Ricoh C901 and the 5010e booklet system 3 years ago to try and cut down on some of my printing costs. I can try and run by one of them to take a peek in a day or two to see the settings, if you still can't get it. We only have a few of the BK5010 left in the field down here most have refreshed and now have the PBM 350/500. Those physically move the stop plates, and will likely affect every size of booklet across the board. It may be called something other than staple stop/fold stop in service mode, but it should be labeled something close to that.ДЄdditionally, because you say that LT folds and staples perfectly, I would probably stay away from some of the hardware-based fold adjustments that are in the manual. Concentrate on the fold stop first to get it folding on center, and then work on the staple stop to get the staples to match the fold. I've had this on a Plock in the past, and I'm pretty sure that's where I made the adjustments. This would seem to be your fix, as you said that LT staples and folds correctly, but DLT does not. If it still doesn't staple or fold properly with the custom size, then I'd go into service mode (instructions are in the service manual), and you should be able to adjust the staple stop and fold stop for each paper size individually. Sometimes these Plocks give wonky output if you use the preset sizes.

#Ricoh plockmatic booklet maker belt removal manual

It appears that you've got the service manual in hand, since you mentioned a paper reset, and EEPROM reset.ДЇirst, I'd try setting it up for 11x17 as a custom size.